McIntosh MC206 manual Specifications Specifications

Specifications

Specifications

Power Output

Minimum sine wave continuous average power output per channel, all channels operating is:

200 watts into a 4 ohm load

120 watts into a 8 ohm load

Rated Power Band

20Hz to 20,000Hz

Total Harmonic Distortion

Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is: 0.005% for 4 or 8 ohm loads

Dynamic Headroom 1.6dB

Frequency Response

+0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz

Sensitivity

1.0 Volt

A-Weighted Signal To Noise Ratio

92dB (113dB below rated output)

Intermodulation Distortion

Maximum Intermodulation Distortion if instanta- neous peak output per channel does not exceed twice the rated output, for any combination of fre- quencies from 20Hz to 20,000Hz, with all channels operating is:

0.005% for 4 or 8 ohm loads

Input Impedance

10,000 ohms

Wide Band Damping Factor 100 at 4 ohms

200 at 8 ohms

Power Requirements

100 Volts, 50/60Hz at 13.2 amps

110 Volts, 50/60Hz at 12.0 amps

120	Volts, 50/60Hz at 11.0 amps
220	Volts, 50/60Hz at	6.0 amps
230	Volts, 50/60Hz at	6.0 amps
240	Volts, 50/60Hz at	6.0 amps

Note: Refer to the rear panel of the MC206 for the correct voltage.

Dimensions

Front Panel: 17-1/2 inches (44.45cm) wide, 7-1/8 inches (18.10cm) high. Depth behind front mounting panel is 18 inches (45.72cm). Clearance required in front of the Front Panel is 1 inch (2.54cm) for knobs.

Weight

57 pounds (25.9 kg) net, 76 pounds (34.5 kg) in shipping carton

14