Appendix D: Equatorial ( Polar Alignment)
PeriodicErrorCorrection(PEC)Training (Polar Alignment and RA Drive Only)
If you wish to improve the tracking performance on your telescope, first, perform the train the drive procedure (see page 57). Then use the Periodic Error Correction (PEC)/Train menu option to remove the slight perturbations from center that occur due to the mechanical nature of a telescope. To perform this procedure, you need to use a
Important Note: In order for the Smart Drive training to operate and be updated properly, you must “park” the telescope (see PARK SCOPE, page 41) when finished with your observing session.
PEC Train Menu Option
To perform the procedure on the RA axis, pick a bright star in the South that has minimal movement and is about 30° above the horizon (Note: If in the Southern hemisphere, pick a star in the North that is about 30° above the horizon).
Important Note: The Train option overwrites any previous PEC data.
1.Select “PEC Train” from the Smart Drive menu (in the “Setup: Telescope” menu) and press ENTER.
2.Look through the reticle. Use the Arrow keys to keep the star centered in the reticle
3.Press MODE to exit.
PEC Update Menu Option
PEC Update does not overwrite the data, but updates the training using information gathered from both the last and the current training sessions. Press the MODE key to exit from this option. If you wish to further refine your training, select this menu again and repeat the procedure.
PEC Erase Menu Option
Select this option to erase all PEC training data.
PEC On and Off Menu Options
Select “On” when you want the telescope to use the training information. Select “Off” when you do not want for the telescope to use the training information.
64