Meade TE346W Setting the ICE Warning Alarm PRE-AL, ACTIVATING/ Deactivating Alarms, Cleaning

SETTING THE ICE WARNING ALARM (PRE-AL)

If Weekday (W) or Single day (S) alarm is MODE, the Ice Warning Alarm (Pre-AL) can be programmed.

•Press ALARM button once to enter into the Ice Warning Alarm setting mode. The abbreviation OFF with a PRE-ALnext to it will be displayed.

•Press and hold ALARM button for two seconds. The number 30 will flash, meaning that if selected, the alarm will sound 30 minutes earlier than the Weekday or Single alarm.

•Select the desired Ice Warning Alarm interval in 15 minutes increments between 15 and 90 minutes, using UP (? ) or DOWN (? )buttons

•Press ALARM button to confirm and exit from the alarm setting mode.

ACTIVATING/ DEACTIVATING ALARMS

•Press ALARM button to enter into the desired alarm mode.

•Press UP ( ? ) to activate alarm and the corresponding icons W, S or PRE-ALwill be displayed.

•Press DOWN ( ? ) to deactivate alarm until “OFF” is displayed.

MAINTANANCE

• Do not mix old and batteries.

CHANGING BATTERIES

• If the low battery indicator lights up, replace batteries in the corresponding unit.

CLEANING

The main unit and remote sensors housings can be cleaned with a damp cloth. Small parts can be cleaned with a cotton tip or pipe-cleaner. Never use abrasive or corrosive cleaning agents or solvents. Do not immerse electronic components in water.

TROUBLESHOOTING

Check here before contacting customer service.

Issue	Symptom	Solution
Main unit	US Atomic Time	Place unit by the window and keep it there
	signal is not	overnight
	received
	Cannot locate	Check batteries
	remote sensor
Remote sensor		Check location
		Press and hold DOWN ( ? ) button on the
		main unit to search for the signal form the
		remote sensor
	Data does not	Initiate manual sensor search (Press and hold
	match data on the	DOWN ( ? ) button on the main unit)
	main unit

12