Melissa 258-014 manual Electrical connection

Hang appliance on wall bracket. Check it is level. Adjust the two rubber spaces at back of appliance if required. Take ap- pliance down again.

Connect flexible hose to extractor nozzle on top of appliance. Note that hose ends have different diameters (printed on outside of hose) Insert the 153 mm diameter end on nozzle. Fit chimney on hood using the 8 small screws supplied on back of appliance. Loosen protective film on back of chimney for peeling off later.

Mount appliance on wall bracket. Extend upper part of chim- ney from lower up to ceiling. Mark position of upper bracket on wall. Push upper part of chimney down again. Screw bracket firmly to wall where marked.

Fit flexible hose on extractor damper in wall or loft. Use an adapter if necessary. Fit 150 mm diameter end to damper.

Electrical connection

Connect to mains socket (which must be accessible and com- ply with relevant regulations).

If connected directly to mains, a multipole circuit-breaker must be fitted between appliance and mains with a minimum distance between contacts of 3 mm and with appropriate ratings for the mains supply and in accordance with relevant regulations.

19