If active carbon filters are to be used instead of extraction damper, they must be fitted on sides of motor:
•Remove filter panel (6) by pressing lock button (5), on lower panel and pull out. Fit carbon filters to motor sides.
•Do not fit flexible hose if carbon filters are to be used.
Extend upper part of chimney from lower, secure to bracket using 2 small screws. Peel protective film off.
Fit the four plastic washers to underside of holes in glass plate (3), carefully place glass plate on appliance with washers facing downwards. Align holes with those on top of appliance. Screw plate to appliance with the 4 screws with rubber wa- shers. Do not
Tip! If rubber washers are displaced, push back into place with screwdriver before inserting screw.
OPERATION
•Press light switch (a) to switch lights (7) on underside of hood on or off.
•Press one of the three suction power controls (b, c or d) to activate hood at desired power setting:
ob = high power
oc = medium power
od = low power
•Press off switch (e) to turn appliance off.
•If two power controls are accidentally activated simulta- neously, the appliance will start at the higher setting.
REPLACING LIGHT BULB
•Switch appliance off.
•Remove filter panel by pressing lock button, lower panel and pull out.
•Carefully insert a screwdriver under light housing edge and lever free from hood underside. Detach light from hood by pressing stud on one side of the white clip and detaching clips.
•Slacken the 4 screws in light back plate, detach plate and detach light. Do not drop light lens!
•Remove halogen bulb.
oWarning! Bulbs in lights can become very hot when in use.
oNever touch bulbs with fingers. Always use a cloth or similar to prevent sweat or dirt from fingers reducing bulb life.
•Insert new halogen bulb. Assemble and fit light housing in reverse order.
20
