ASSEMBLING THE VACUUM
CLEANER:
Fitting the tube:
-Press the buttons on the end of the tube and insert the tube into the
Removing the hose:
-To release the hose, press the buttons on the end of the hose and pull the hose firmly from the air intake duct.
OPERATION
-Do not remove the plug from the socket by pulling the cable or the appliance itself.
-Do not run the appliance over the power cable.
-Do not use the appliance to vacuum up lit matches, cigarette ends or hot ashes.
-Do not use the appliance on wet surfaces.
-Do not obstruct the air intake or the air outlet vents.
-Do not use the appliance to vacuum up needles, drawing pins or string.
INSTRUCTIONS FOR USE
-Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red mark.
To rewind the power cable, press the rewind button with one hand, and guide the cable with the other hand to ensure that it does not whip causing damage.
-Press the ON/OFF button to switch the appliance on.
-The vacuum cleaner’s three special nozzles can be stored in the storage compartment (14). Remove the floor nozzle and fit the special nozzle required to the end of the telescopic tube. Note: The brush nozzle (18) must be placed over the joint nozzle (17). Close the cover again before turning the vacuum cleaner on (the buttons (15) must be clicked in place).
-While in use, the suction force can be regulated by opening and closing the air valve on the handle or adjusted electronically using the suction force regulation slider (13).
The nozzles are to be used as follows:
Floor nozzle (11):
Floors, carpets and rugs
Extra nozzle for hard floors (19):
Hard floors
Furniture nozzle (16):
Furniture, curtains, drapes, etc.
Joint nozzle (17):
Radiators, corners, skirtings, etc.
Brush nozzle (18):
Shelves, books, lampshades, etc.
REPLACING THE DUST BAG:
After removing the hose, open the front cover by pressing the lock lever and pulling upwards. Remove the
Remove the dustbag from the holder. Replace the dustbag by inserting the carton of the dustbag into the grooves of the dustbag- holder.
REPLACING THE MOTORFILTER
The
Open the front cover, and gently pull out the filter free of the holder.
Insert a new
REPLACING THE HEPA FILTER
Open the cover (2) by lifting the buttons (15). Lift the old HEPA filter out and replace with the new HEPA filter. Close the cover again before turning
the vacuum cleaner on (the buttons (15) must be clicked in place).
DO NOT USE THE VACUUM CLEANER WITHOUT BOTH FILTERS IN PLACE!
12
