KEY TO THE VACUUM CLEANER’S PARTS
1.Floor nozzle
1a. Brush change button
2.Locking mechanism
3.Telescopic tube
4.Hose
5.Air valve
6.Handle
7.Hose connector
8.Dust container
9.Release button
10.Carrying handle
11.Button for automatic cord rewind
12.On/Off button
13.Button for controlling suction strength
14.Parking holder
15.Cord and plug
16.Exhaust filter
17.Holder for combination nozzle
18.Window for dust container
19.Combination nozzle
19a. Combination nozzle, extended
PREPARING THE VACUUM CLEANER
•Attach the hose (4) to the vacuum cleaner by inserting it into the hose connector (7) until you hear a click. To remove the hose, press the buttons at the side of the hose and pull it out of the hose connector.
•Fit the telescopic tube (3) into the other end of the hose, and attach the floor nozzle (1) to the end of the tube.
•You can adjust the length of the telescopic tube by pushing the locking mechanism (2) down and pulling on the bottom section of the tube until it reaches a suitable length.
When parking, shorten the tube as far as possible.
•The vacuum cleaner’s combination nozzle (19) is used for particular vacuuming tasks (see under Use). Remove the floor nozzle and fit the combination nozzle to the end of the telescopic tube.
USE
•Pull the cord (15) out of the vacuum cleaner. The cord must not be pulled out any further than the red mark. Plug in and switch the power on.
•Press the on/off button (12) to start and stop the vacuum cleaner.
•While in use, the suction strength can be regulated by opening and closing the air valve (5) on the handle at the end of the hose.
•The suction strength can also be adjusted electronically using the button for controlling suction strength (13). Suction strength increases when the button is turned towards "Max", and reduces when it is turned towards "Min".
19