Melissa 640-142 Operation, Assembling the Vacuum Cleaner, Floor Brush USE, Instructions for USE

OPERATION

-Do not remove the plug from the socket by pulling the cable or the appliance itself.

-Do not run the appliance over the power cable.

-Do not use the appliance to vacuum up lit matches, cigarette ends or hot ashes.

-Do not use the appliance on wet surfaces.

-Do not obstruct the air intake or the air outlet vents.

-Do not use the appliance to vacuum up needles, drawing pins or string.

-While in use, the suction force can be regulated by opening and closing the air valve on the handle. It can also be adjusted electronically using the suction force regulation button.

ASSEMBLING THE VACUUM CLEANER:

Fitting the tube:

-Press the buttons on the end of the tube and insert the tube into the air- intake.

Removing the hose:

-To release the hose, press the buttons on the end of the hose and pull the hose firmly from the air intake duct.

FLOOR BRUSH USE

-Press the button on the floor brush, so the brush is shown for cleaning hard floors

-Press the other button to withdraw the brush for cleaning carpets.

INSTRUCTIONS FOR USE

-Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red mark.

To rewind the power cable, press the rewind button with one hand, and guide the cable with the other hand to ensure that it does not whip causing damage.

-Press the ON/OFF button to switch the appliance on.

REPLACING THE DUSTBAG:

After removing the hose, open the front cover by pressing the lock lever and pulling upwards.

Remove the dustbag-holder. Remove the dustbag from the holder. Replace the dustbag by inserting the carton of the dustbag into the grooves of the dustbag-holder.

REPLACING THE MOTORFILTER

The motor-filter is the filter placed behind the dustbag:

Open the front cover, and gently pull out the filter free of the holder.

Insert a new motor-filter.

REPLACING THE EXHAUST-MICRO- FILTER

The exhaust-filter is the filter placed on the back of the vacuum cleaner:

Press the release-button on the exhaust grating and pull it out at the same time. Remove the exhaust-filter and insert a new exhaust-filter.

Insert the exhaust grating back in place.

15