Melissa 670-012 Introduction, Important Safety Measures, Overview Of Functions, Fitting Wheels

UK

INTRODUCTION

To get the best out of your new oil radiator, please read these instructions carefully before using it for the first time.

We also recommend that you keep the instructions for future reference, so that you can remind yourself of the functions of the device.

IMPORTANT SAFETY MEASURES

-Read the instructions carefully before using the device for the first time.

-The device may only be used in accordance with the instructions in this manual.

-When unpacking the device, check that it has not been damaged during transport.

-Do not immerse the device in any form of liquid.

-Remove the plug from the socket when cleaning, or when the device is not in use.

-If the cord, plug or the device itself should become damaged, do not attempt to repair the damage yourself, but instead take it to a specialist for repair, as special tools are required.

-For indoor use only.

-Ensure that the cord does not come into contact with heat sources such as hotplates, cookers, etc., as this may damage the cord.

-The device must not be covered or built in.

OVERVIEW OF FUNCTIONS

1 7 6

9

3

2

5 8

4

1.Heating ribs

2.Thermostat button

3.Switches (1 and 2) with indicator lights

4.Cord rewind

5.Wheels

6.Mounting clamp

7.Wheel disc

8.Wing nuts

9.Carrying handle

FITTING WHEELS

-Turn the device upside down.

-Position the clamp and wheel disc around the space between the first and second rib.

-Put the wing nuts on and tighten them.

-Screw the wheels firmly in place in the outer holes on the wheel disc.

-Turn the device over so that it stands on its wheels.

-Wait 5 minutes before using the device.

USE

-Make sure the device is on a stable and level surface.

-Select the desired wattage using the 2 switches. There are 3 possible combinations - see below:

(5 ribs - 670-010):

Switch I	the device runs on 500 W.
Switch II	the device runs on 500 W.
Switches I + II	the device runs on full wattage 1000 W.

(7 ribs - 670-011):

Switch I	the device runs on 600 W.
Switch II	the device runs on 900 W.
Switches I + II	the device runs on full wattage 1500 W.

(9 ribs - 670-012):

Switch I	the device runs on 800 W.
Switch II	the device runs on 1200 W.
Switches I + II	the device runs on full wattage 2000 W.

(11 ribs - 670-013):

Switch I	the device runs on 800 W.
Switch II	the device runs on 1200 W.
Switches I + II	the device runs on full wattage 2000 W.

-Plug in. The device is now connected.

-Set the thermostat dial at the highest setting.

-Once the room temperature reaches the desired level, push the thermostat down until the indicator light goes out.

-If you want to change the room temperature, push the thermostat button up to raise the temperature or down to lower it.

-When the device is switched on, the indicator light will be on as long as the room temperature is lower than the temperature set on the thermostat.

-After use, set both switches to 0 position and push the thermostat down to the lowest point (smallest dot). Then remove the plug from the socket.

CLEANING

Always unplug the radiator and let it cool before cleaning. Clean it with a dry or damp cloth or using a weak soap solution where necessary. Do not use abrasive cleaning agents.

10