SAFETY INFORMATION
LIGHTING SYSTEM SAFETY
DANGER
NEVER use lighting system in rain, snow or areas of high humidity that could generate electrical storms.
WARNING
NEVER disconnect any emergency or safety devices. These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death. Disconnection of any of these devices will void all warranties.
CAUTION
NEVER attempt service on a running machine.
NOTICE
To prevent the lighting system from overturning, NEVER use in winds that exceed 22 mph (10 m/s).
The lighting system should only be used in temperatures between 23° to 104°F
ALWAYS keep the lighting system in proper running condition.
Fix damage to lighting system and replace any broken parts immediately.
ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.
LAMP SAFETY
WARNING
NEVER attempt to replace lamp with the power on. Always unplug the power cord from the generator or power source when changing the lamp.
ALWAYS allow a sufficient amount of time for the lamp to cool before changing.The possibility exists of severe burns.
CAUTION
NEVER use force when installing the lamp.Excessive force could cause the lamp to break, causing bodily harm.
NOTICE
NEVER leave any grease or oil residue on lamp surface when replacing or removing lamp. This can create hot spots, reducing the service life of the lamp.
ALWAYS make sure lamp surface is clean and dry.
ALWAYS replace with MQ recommended type lamp. See parts section of this manual.
If applicable, ALWAYS make sure the lamp guard is installed correctly. NEVER deform the lamp guard.
NEVER unplug the lamp’s AC power cable during operation.
ALWAYS have a trained technician to install and remove lamp or replace any damaged fi xture wiring.
GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09) — PAGE 7
