SETUP
GBS SETUP
1.Attach one of the clamps that come with the GBS to the external support pole. The clamps may be attached to vertical, horizontal, or angled pole. See Figure 11.
VERTICAL
EXTERNAL
SUPPORT
POLE
CLAMP
LOCKNUT
CLAMP
ANGLED |
|
| HORIZONTAL | |
EXTERNAL |
|
| ||
|
| EXTERNAL | ||
SUPPORT |
|
| ||
|
| SUPPORT | ||
POLE |
|
| ||
|
| POLE | ||
|
| LOCKNUT |
| |
|
|
|
| |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
Figure 11. Clamp Attachment
2.Using a 19 mm wrench, tighten the locknut securely. See Figure 11.
3.Attach the other clamp to the external support pole about 7 inches (140 mm) lower than the previously installed clamp. See Figure 12. If using horizontal external support poles, a second pole is needed.
7.0 INCHES
(140 MM)
Figure 12. Distance Between Clamps
4.Attach the straight pole to the clamps.Tighten locknuts on both clamps. See Figure 13.
STRAIGHT
POLE
CLAMPS
Figure 13. Straight Pole Attachment
WARNING
Always securely tighten the locknuts when assembly is used to prevent the lighting system from falling off which can cause injury or equipment damage.
5.Place the offset pole (or an optional straight pole, if desired) on top of the straight pole. Tighten knob or bolt securely. See Figure 14.
STRAIGHT
OFFSETPOLE
POLE
BOLT
KNOB
Figure 14. Offset Pole Attachment
WARNING
Always securely tighten the knob on the offset or the bolt on the straight pole when assembly is used to prevent the lighting system from falling off which can cause injury or equipment damage.
GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09) — PAGE 19
