Multiquip GBWE Nameplates And Decals Gbs, GloBugTM Lighting System, Model Serial No, A-0000000-00

NAMEPLATES AND DECALS (GBS)

2

NEVER operate any of the GloBug lighting systems or handle any electrical equipment while standing in water, while barefoot,	To prevent burns, NEVER touch	Once lamp is turned OFF, Allow lamp to cool down before turning back
while hands are wet, or in the rain. A dangerous electrical shock could occur causing Severe Bodily Harm or even Death !	lamp while lamp is on. Lamp	on. It will take about 5 minutes before lamp can be turned back on.
NEVER disconnect the connector when power is applied. The possibility exists of Electrical shock or equipment damege.	surface gets extremely hot!	ALWAYS disconnect the AC power cable from generator first, before
Make sure the power cable from the generator is connected to the lamp power cable securely. A loose connection may cause	ALWAYS allow sufficient time	shutting down generator.
	for lamp to cool down before
a short circuit. ALWAYS turn OFF generator before performing maintenance.		ALWAYS turn on generator first,before connecting the AC power
	touching.
To prevent breaking, NEVER use in strong winds that makes balloon deformed considerably.		cable to the generator.
	To avoid injury, you MUST read
To avoid accident or injury NEVER exceed a travel speed of 6 MPH when using lighting system on mobile equipment.		To prevent the lighting system from breaking, NEVER use in strong
	and understand operator's manual
To avoid accident or injury ALWAYS make certain hardware is securely fastened on pipe clamps.	before using this machine.	winds that makes balloon deformed considerably.

4

1

GloBugTM Lighting System

5

Lamp OFF Push the button in the hole with a small

switch flat-blade screwdriver (or similar tool) for 3 seconds. LED will turn green.

MODEL SERIAL NO.

6

3

A-0000000-00

PAGE 38 — GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09)