Melissa 676-001 Safety precautions, Operating panel, Key to display, Before use, Permanent drain

UK

Before using your dehumidifier for the first time, please read this user guide. We also recommend that you save it in case you need it at a later point to remind yourself of the device’s functions and maintenance.

Safety precautions

-Please note that the dehumidifier's voltage is equivalent to the mains voltage.

-Do not plug in to the mains where other electrical appliances are already plugged in.

-Use the dehumidifier only for the purpose(s) defined in the user guide.

-Never insert your fingers, pencils or other objects into the air intake during operation.

-Switch off before moving or cleaning the device.

-Do not expose to strong heat, as this can cause damage to the electrical components.

-Do not immerse in any form of liquid.

-Always keep out of the reach of children.

-Do not run the cable under carpets, rugs, etc.

-Ensure the cable is kept away from busy areas to avoid anyone tripping over it.

Operating panel:

1.Start/stop button

1.

Key to display.

Tank full indicator: lights when the tank is full.

A lamp will light when the device is switched on.

Before use

Find a suitable place close to a mains electricity socket.

The dehumidifier is fitted with for easy manoeuvrability. Caution is advised in placing the device for operation.

It should not be placed near heating appliances or other heat sources, or in direct sunlight as this will cause reduced performance.

Improved performance can be achieved by ensuring the room is maintained at a temperature over +5C°.

Plug in to a mains plug socket (220-240V ~50Hz) Ensure that the water tank is positioned correctly, or the dehumidifier will not start.

-For indoor use only.

-	Do not cover. Danger of overheating!	If the dehumidifier is to be used near swimming pools or
-	Do not use if the device or cable become damaged. Take it to	bathrooms, it must be securely mounted and be connected to
	a specialist for repair.	earth.
-	If the device has been transported in a horizontal position, oil	Installation:
	from the compressor can have leaked into the system. It is
		It is important that the device is positioned on a firm level surface
	therefore important to let it stand upright for a few hours
	before use. This will allow the oil to run back into the	well away from other objects. There must be a minimum distance
	compressor and avoid damage.	of 30 cm from walls or other objects. Do not cover the air exhaust
		vent.
The volume of moisture the device can extract from the air		- To start, press the “I/O” button (on/off)
		- Full water tank
depends on temperature, level of humidity and placing. The
weather outside can also have an effect on how much moisture		- The tank-full indicator will light when
can be extracted from the air. In cold weather, the relative humidity		the tank is full. The device will switch
falls causing a corresponding fall in the amount of moisture that		off automatically.
can be extracted.		- Do not empty the tank while the
Key:		device is running. It must be at a
		complete standstill before the tank
1.	Operating panel	can be removed.
2.	Air intake	- When the tank is replaced in the
3.	Water tank (4 litres)	device, it is ready to operate again.
4.	Wheels
5.	Air exhaust	Permanent drain.

6.Permanent drain hole

7.	Cable winder	A hose with an internal diameter of 11.5 mm is required for a
		permanent drain.( not incl.)
8.	Cable
		- Remove the blank on the back of
1.		the device with a screwdriver or
		similar implement. Pass the hose
	5.	through to the drain nozzle and
2.		secure.
		- Ensure there are no kinks in the
		hose and that it is not trapped.
	6.	Maintenance:
3.		Always remover the plug from the socket before cleaning.
	7.
4.	8.

10