•Charging capacity of the battery unit depends on the amount of sunlight and is thus depending on geographical position and weather. Obviously, in Northern Europe the solar cells do not have the same effect as in countries with more sunshine hours, which may affect the effectiveness of the light. If the weather is severely cloudy
or on short winter days, recharging may sometimes be insufficient for normal use of the light.
INSTALLATION
Before installation, keep the following in mind:
•The solar cell panel (10) and the battery unit
(3) with the light (1) are not to be placed so that the cord (14) cannot reach from the solar cell panel to the light. Measure out the distance between the mounting positions before drilling any holes.
•Make sure, the cord is not trapped in doors, windows or similar.
•Secure the cord with cord fasteners.
•The motion sensor (5) is equipped with buttons for both light level (6), time (7) and sensitivity (8). Make sure, it is mounted and adjusted so that is not unnecessarily activated.
•The motion sensor must not be mounted where it can be affected by artificial light since this will prevent the light from switching on automatically.
Mounting of solar cell panel
•The solar cell panel can stand on the triangular base (12) or be mounted on a wall by means of the screw holes (13).
Mounting of light and sensor units
•Drill two holes in the wall in a vertical line 136 mm apart.
•Screw two screws almost all the way in.
•Attach the light to the screw heads and make sure it is securely fastened. However, it must be possible to remove the light when turning the appliance on or off.
PREPARING THE APPLIANCE
•Attach the cord from the solar cell panel to the socket on the battery unit (9).
•Adjust the solar cell panel by turning it in the swivel joint (11) in order that it may absorb as much sunlight as possible.
•Adjust the light and the motion sensor by turning them in the swivel joints (2) until each points to the direction required. The swivel joints can be tightened using the small finger screw once every part has been correctly adjusted.
•Turn the on/off button (4) at the reverse side of the battery unit to the position "Auto".
•Return the battery unit with the light to its proper position.
•Leave the batteries to fully charge for two days before using.
USING THE APPLIANCE
•Turn the on/off button to the “AUTO” position (on).
•The light now switches on when it is dark and the motion sensor registers movement.
•The light switches off in sunlight and is automatically recharged. Use the button “DARKNESS” (light level adjuster) to adjust how dark it should be, before the appliance switches on.
•The motion sensor registers movements within a distance of min. 5 m. Use the button “SENSITIVITY” (sensitivity adjuster) to adjust the sensitivity.
•Use the button “TIME” (timer) to adjust the interval, the light is to be switched on, every time it is activated. The time can be set for between approx. 3 seconds and approx. 1 minute.
•If the light does not switch on, possible causes are that the motion sensor is affected by artificial light sources, that the batteries are flat or that the on/off button is at the position “OFF” (off).
•Turn the on/off button to position “OFF”(off), if the light is not to be used for a longer period of time.
CLEANING
•Regularly wipe the solar cell panel, the motion sensor and the light with a well- wrung cloth.
•Never use corrosive or abrasive cleaning agents as they may damage the plastic parts of the appliance.
INFORMATION ON DISPOSAL AND RECYCLING OF THIS PRODUCT
Please note that this Adexi product is marked
with this symbol:
This means that this product must not be disposed of together with ordinary household waste, as electrical and electronic waste must be disposed of separately.
15
