Melissa 753-089 manual Operating Panel, Symbols on the Display, Operating the Microwave Oven

KEY TO THE MICROWAVE OVEN’S PARTS PREPARING THE MICROWAVE OVEN

A.Control panel

B.Spindle

C.Turning ring

D.Glass turntable

E.Window

F.Door

G.Dowels (safety lock)

H.Cooking grid

OPERATING PANEL:

1.Display

2.Button for automatic defrosting (Defrost By W.T)

3.Button for setting clock/timer (Clock/Pre-Set)

4.Button for defrosting by time (Defrost By Time)

5.Button for selecting auto-menu (Auto Cook)

6.Start button (Quick Start/Start)

7.Function button (Micro/Grill/Combi)

8.Stop button (Stop/Cancel)

9.Knob for setting time, power and weight (Time/Power/Weight)

SYMBOLS ON THE DISPLAY

(a)	Microwave
(b)	Grill	a	b
(c)	Defrost
(d)	High power
(e)	Low power
(f)	Clock/timer
(g)	Child lock
(h)	Pre-set programs
(i)	Gram (g)
(j)	Millilitre (ml)	f	g

			Each individual microwave oven is checked at the factory, but for
			safety’s sake, after unpacking the oven, you should check
			carefully that the microwave oven has not been damaged during
			transport. Check whether there is any visible damage (e.g. in the
			form of dents or similar), if the door closes properly, and if the
			hinges are in order. If it appears that the microwave oven has
			been damaged, you must contact the shop where you bought it,
			and do not use it until it has been checked by an authorised
			specialist.
			Before using the microwave oven, you should check that you
			have removed all packaging from it both inside and outside.
			Positioning the microwave
			The microwave oven should be placed on a flat surface, with
			clearance of at least 10 cm at the rear, 5 cm at the sides and 20
			cm above to ensure sufficient ventilation. Do not remove the feet
			of the microwave oven. This oven is not suitable for fitting in, and
			you must check that the vent holes on the top of the cabinet are
			not covered. If they are covered while the microwave oven is in
			use, there is a risk of it overheating. The microwave oven cannot
			then be used until it has cooled down.
			Do not place the microwave oven or the cord near hot areas, for
			example gas rings and electric hotplates.
			Connecting the microwave oven
			The microwave oven must be connected to a 230-volt AC
1			current, 50 Hz. The guarantee is not valid if the microwave oven
			is connected to the wrong voltage.
2			Installation of the glass turntable
3
			Before using the microwave ensure that:
4			• the turning ring (C) is in the recess around the spindle (B), and
5			that
6			• the glass turntable (D) is fitted to the turning ring.
7			Setting the clock
8			When you have lugged the microwave oven in, the display shows
			"0:00".
9			1. Press the button to set the time (3) once. The hour number
			now flashes.
			2. Turn the knob (9), until the display shows the required hour.
			3. Press the button to set the time (3) again. The minute number
			now flashes.
			4. Turn the knob (9), until the display shows the required minute.
c	d	e	5. Press the button to set the time (3) again to enter the setting.

OPERATING THE MICROWAVE OVEN

The microwave oven is operated in the following way.

• Place the food to be cooked in the microwave oven and

		close the door (F).
		• Select the cooking function and power and preparation time,
		if relevant (described in detail below). The microwave oven
h	i	starts automatically.
		j
		• Cooking can be interrupted at any time by pressing the stop
		button (8). One press temporarily interrupts cooking, two
		presses permanently interrupts cooking. Cooking can also be
		interrupted temporarily by opening the door. A temporary
		interruption to cooking can be cancelled by pressing the start
		button (6).
		• Once the cooking time has passed, the microwave oven
		stops automatically and 5 beeps are heard.

20