19.This appliance is intended to be used in households or other similar environments such as:
•Staff kitchen areas in shops, offices and other working environments
•By clients in hotels, motels and other residential type environments
•Farm houses
•Bed and breakfast type environments
Operating guidelines for first use:
1.Prior to initial use, clean the appliance by going through several boiling cycles, using clean water with each cycle and filling the kettle (4) to its upper marking. The water will reach boiling point after approximately 5 minutes and will then switch off auto- matically.
Operation:
(Please refer to Figure 1)
1.Place the cordless base (7) on a firm and level surface.
2.Pour the desired amount of clean water into the kettle (4). Do not touch any part of the kettle except the handle while the appliance is in use. Ensure that the lid (1) is prop- erly closed. The amount of water can be measured by the level mark on the outside of the kettle. Always pay attention to the minimum and maximum levels and ensure that the lid (1) is properly and firmly closed.
3.Position the kettle in such a way on the sub base (6) so that the underside of the kettle fits precisely into the contact on the base.
Insert the plug into a wall socket.
4.Put the on/off switch (3) to the ‘1’ position to start the boiling process. The indicator lamp will light up.
5.As soon as the water reaches boiling point, the on/off switch (3) will return automati- cally to the “0” position. The indicator lamp will go out. The kettle can also be switched off manually by putting the on/off switch to the “0” position.
6.The hot water may now be poured safely through the spout.
7.This kettle is equipped with a safety
rated, the safety cut out will automatically switch off the heating element.
8.If point (7) occurs remove the plug from the wall socket immediately and refill the kettle after an adequate cooling down period, about 15 to 20 seconds.
Warning:
1.DO NOT SUBMERSE IN WATER.
2.Only use the base provided with this kettle.
3.If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person in or- der to avoid a hazard.
Descaling:
1.Should the appliance switch off before reaching boiling point this is a sign that descaling is necessary.
2.A regular descaling agent may be used. Ensure that the instructions for use are adhered to. In order to avoid spillage do not fill the kettle up to the max mark as the descaling agent may cause the water to foam.
3.To clean the kettle thoroughly of any decal- cification residues, boil the kettle several times using clean water with each cycle. Rinse the kettle with clean water afterwards.
Cleaning and care:
1.Before cleaning the appliance, ensure that it is disconnected from the power supply and has cooled down completely.
2.Do not use abrasives or harsh cleaning solutions.
3.Do not immerse the base or the kettle in any liquid. To clean the exterior use a slightly damp,
4.It is advisable to remove lime deposits from the kettle at regular intervals.
Specifications:
Supply voltage:
Power consumption:
Volume: 1.7L
22400RDA_IM.indd 3
2013/08/21 12:03:02 PM
