Mellerware 2650DA manual Electronic speed control, Timer function, Accessories Whisk accessory H

Models: 2650DA

1 5
Download 5 pages 30.25 Kb
Page 4
Image 4
Electronic speed control:

Electronic speed control:

The speed of the appliance can be regulated by using the speed regulator control (D). This func- tion is very useful, as it makes it possible to adapt the power of the appliance to the type of work that needs to be done.

The speed control can be used for the desired function as is described in the accessories sec- tion.

Timer function:

1.The appliance’s operating time can be con- trolled.

2.To set an operating time simply select it by us- ing the time selection buttons (G) to a maxi- mum of 10 minutes, with 10 second intervals. By keeping “+” or “-” pressed, the selected time will change more quickly.

3.The programmed time or remaining time will be shown on the LED display (F).

4.By selecting the desired speed the LED display will show the remaining time in 1 second intervals.

5.The time and operating of the appliance can be paused by moving the selector knob to “0”. Time and operating will resume once the speed has been selected again.

6.Once the programmed time has elapsed, the appliance will stop. Move the selector knob to “0”.

7.To change the set time move the selector knob to “0” and press “+” or “-” to reset the desired time. Once selected, reset the desired operat- ing speed.

8.To reset the timer, select “0” and then press both select time buttons at the same time until 00:00 is shown on the LED display.

9.If a specific operating time has not been set, the LED display will show the time elapsed since the operating speed was selected.

Once you have finished using the appliance:

1.Turn off the appliance by selecting 0 on the speed regulator.

2.Unplug the appliance to the mains.

3.Put the cable back in the cable housing.

4.The cable housing enables the cable to be stored and pulled out to the required length for operating the appliance, preventing hazardous situations.

5.Take off the lid.

6.Press the connect/disconnect button of the up- per part, while raising the upper part.

7.Remove the bowl from the base by turning it in an anti-clockwise direction.

8.Clean the appliance

Accessories:

Whisk accessory (H):

This accessory is used for whipping cream, stiff- ening egg whites, making smoothies, light cakes, meringues, mousses and soufflés.

Do not use this accessory for mixing heavy masses (e.g. fat and sugar) as it may damage the appliance.

Use the speed control to gradually increase until reaching the maximum setting.

Note: minimum quantity of 3 eggs, maximum quantity of 12.

Mixer accessory (I):

This accessory is used for mixing food, making biscuits, pasta, fillings and mashed potatoes.

It is recommended that intermediate speeds are used from 2-6, depending on the type of mixes.

Kneading accessory (J):

This accessory is used for kneading bread, pizza dough and dense cakes.

Do not use speeds greater than 1.

Maximum quantity of flour: 1,200 gr.

Safety thermal protector:

The appliance has a safety device, which pro- tects the appliance from overheating.

If the appliance turns itself off and does not switch itself on again, disconnect it from the mains supply, and wait for approximately 15 minutes before reconnecting. If the machine does not start again seek authorised technical assistance.

Cleaning

Disconnect the appliance from the mains and let it cool before undertaking any cleaning task.

Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry.

Do not use solvents, or products with an acid or base pH such as bleach, or abrasive products, for cleaning the appliance.

Do not let water or any other liquid get into the air vents to avoid damage to the inner parts of the appliance.

Do not submerge the appliance in water or any other liquid, or place it under a running tap.

It is advisable to clean the appliance with a damp(not wet) cloth regularly and remove any food remains. The bowl, splash guard, spatula and attachments are suitable for cleaning with hot soapy water.

After washing, dry all the parts before fitting them together and storing.

Anomalies and repair

- Take the appliance to an authorised technical support service if problems arise. Do not try to dismantle or repair without assistance, as this may be dangerous.

Page 4
Image 4
Mellerware 2650DA Electronic speed control, Timer function, Once you have finished using the appliance, Mixer accessory