USING IT FOR THE FIRST TIME
•When first using this brewer, please carry out a cleaning proceedure before it is
MAX, tighten the filter in place of brewer; turn the switch to brewing mode 
. At the same time, place an adequate container under the filter holder and make sure the two brewing spouts are over the container. Now, you can hear the motor of the pump rumbeling. Water may take a while to come out of the spout if you are using it for the first time, or if it has not been used for some time. The cleaning procedure is completed when half the water is left in the container. now you can proceed to the
PRE-HEATING THE COFFEE MACHINE
•For the proper function as well as longer life in using the coffee brewer, remember to fill with
water before the heater mode 
of the boiler is turned on: by turning the selector switch to
brewing mode , and wait until water drips out from the spout.
•For optimum
can be left in the heater mode 
for approximately
•To install the filter properly, simply hold the filter handle, flip handle clip backward and place it level under the heater. Align the filter holder so that the handle is pointing directly in fornt of the heater. Now rotate the handle from left to right until it is tight.
NOTE:
*Although the optimum
in the heater mode 
, the machine can be operated after two minutes once the OK light 
is lit.
*Fix the filter as tight as possible in the installation to avoid water leaking from the filter.
•Replace the tank by connecting the valve at the bottom of the tank with the hole in the base of the machine.
NOTE: Do not operate the appliance without water in the tank and always remember to fill the tank when the water level goes below the MIN level.
The brewing of espresso requires several attachment to be placed in the coffee filter. The general operations are described as below:
2-cups coffee (with ground coffee)
a.Make sure the sealing ring has been placed in the filter holder before fitting the
b.Fill in the filter basket with appropriate amount of ground coffee (12g recommended) and follow general brewing procedures.
c.After brewing, grip the filter handle and pressure reducer
firmly (hold for 5 seconds) when removing the filter holder, so that the pressure
remaining in the filter will be release and the filter can be removed safely.
NOTE:
*Please check if the sealing ring has been placed properly in the coffee filter before
fitting in the coffee filter basket.
*After brewing, remember to grip the pressure reducer together with the filter handle firmly when removing the filter so as to avoid the danger of accidental pressure release.
*Every time after brewing, remember to clean your coffee filter for hygene and for preventing the coffee grounds from blocking the hole of the reducer.
HOW TO PREPARE ESPRESSO COFFEE
FILLING THE WATER TANK:
•To remove the water tank simply pull upwards and fill the tank at the sink. Do not exceed the MAX level on the water tank. The tank may also be filled without removing it, simply by pouring water into it directly from a jug.
1-cup coffee (with ground coffee)
a.Make sure the one cup pressure valve attachment has been placed in the filter holder before fitting in the one cup filter basket;
b.Fill in the filter basket with appropriate amount of ground coffee (6g recommended) and follow general brewing procedures.
c.After brewing, grip the filter handle and
