Mellerware 1200W, 29200 manual Cup coffee with ESE coffee pod

pressure reducer firmly (hold for 5 seconds) when removing the filter holder, so that the pressure remaining in the filter will be release and the filter can be removed safely.

NOTE:

*When placing the pressure valve attachments into the coffee filter, please check if the sealing ring has been fitted in the filter holder. Otherwise, it may fail to brew cappuccino because the filter

has not been completely sealed.

* After brewing, remember to grip the pressure reducer together with the filter handle firmly when removing the filter so as to avoid the danger of accidental pressure release.

*Every time after brewing, remember

to clean your coffee filter for hygene and for preventing the coffee grounds from blocking the hole of the reducer.

1-cup coffee (with ESE coffee pod)

a.Make sure the l-cup pressure valve attachment has been placed in the filter holder before fitting in the 1-cup filter basket;

b.Fit in a ESE coffee pod to the filter and put the O-ring (for ESE POD) on top of it. Follow general brewing procedures.

c.After brewing, grip the filter handle and pressure reducer firmly (hold for 5 seconds) when releasing the filter holder, so that the remaining pressure in the filter will be released and the filter can be

removed safely. NOTE:

* When placing the

pressure valve attachments into the coffee filter, please check if the sealing ring has been fitted in the filter holder. Otherwise, it may fail to brew Espresso because

the filter has not been completely sealed.

*When using ESE coffee pod, fit in

the o-ring after fitting in the ESE coffee pod. The ESE Coffee pod have to be purchased separately.

*When placing the pressure valve attachments into the coffee filter, please check if the sealing ring has been fitted in the filter holder. Otherwise, it may fail to brew Espresso because the filter has not been completely sealed.

Do NOT unscrew and remove the filter basket from the machine immediately after brewing the coffee lest the coffee remains will spill out and stain your clothes or even burnt your skins. Leave for a while (around 5 minutes) before removing the filter holder is appropriate.

1.After preheating the coffee unit as described above, put a coffee cup under the filter and

set the switch to the Brewing position . At this point, hot water flows out from the coffee outlet of the filter. Turn the switch to the Heater

position . again when the Ok light * is off. Empty the cup, and detach the filter.

2.Insert the filter basket to the filter holder. Then, put ground coffee into the filter holder and press it with the coffee tamper.

NOTE:

*The manufacturer has provided two types of filter holder. The smaller one is for the one cup, recommend to hold 6g ground coffee for approximate 30ml espresso; the bigger one is for two cups, recommend to hold 12g ground coffee for approximate 60ml espresso.

*Tamping the coffee gives a better quality espresso. If you press too hard, the coffee comes out slowly and the créma is dark in colour. If on the other hand, the coffee is not pressed enough, it will come out too quickly and the créma will be light in colour.

*Remove any excess coffee from the filter

holder rim and attach the filter holder to the machine.

NOTE: Tighten the filter handle to avoid leaks.

4.Place the pre-heated coffee cup underneath the filter holder, where coffee drips via the holes. Unless you need to make two cups of coffee at the same time.

5.When the Ok light is lit, you may turn the

switch to the Brewing position .At this point, espresso coffee flows into your cup continuously. Turn the switch to the Heater

position	when there is enough coffee in
your cup.

6.After brewing, turn the switch to OFF position and unplug the coffee maker from the electric socket.

7.After brewing , wait after the product is cool, grip the handle of the filter holder (together with the pressure reducer paddle) and turn the holder from right to left for removal simultaneously turning the clip of the handle