situated further back from the front part of the motor body (A). Using these 4 screws, attach the rear grille (Q), ensuring that the carrying handle
(E)is on the upper part of the appliance.
•Insert the fan propeller (D) onto the motor shaft
(R)until the hole in the fan propeller coincides with motor shaft groove. Next use the fan propel- ler tightening screw to tighten it completely.
•Position the front grille (P) on to the back grille (Q), press them together ensuring that the clips are in alignment. Make sure that the hole in the front grille coincides with the security screw (O).
•To ensure that the front and rear grilles are se- curely fitted together secure each one with the security screw (O). This should be introduced through the hole so that the grille’s cannot be
separated without the use of a tool.
Instructions for use:
•Unroll the cable completely before plugging it in.
•Connect the appliance to the mains electrical supply.
•Guide the appliance to direct the flow of air in the desired direction.
•Select the desired speed.
Height Adjustment:
The height of the appliance can be adjusted by loosening the control, setting the appliance to the desired height and tightening the control again.
Oscillating function:
•The oscillating function makes it possible to di- rect the flow from the apparatus so that it auto- matically alternates over a range of 75º.
•To activate this function press the oscillating function control (T).
Once you have finished using the appliance:
•Stop the appliance, selecting position 0 on the selector control.
•Unplug the appliance from the mains power sup- ply.
35920A_IM.indd 4
Carry handle:
This appliance has a handle on the back to make it easy and convenient to transport.
Safety trip switch:
The appliance has a safety trip switch that protects the appliance from overheating.
Cleaning:
•Disconnect the appliance from the mains and al- low it to cool before undertaking any cleaning task.
•Clean the equipment with a damp cloth with a few drops of
•Do not use solvents, or products with an acid or base pH such as bleach, or abrasive products, for cleaning the appliance.
•Do not let water or any other liquid get into the air vents to avoid damage to the inner parts of the appliance.
•Do not submerge the appliance in water or any other liquid.
Anomalies and repair:
•Take the appliance to an authorised technical support centre if problems arise. Do not try to dismantle or repair without assistance, as this may be dangerous.
•If the connection to the mains has been dam- aged, it must be replaced and you should pro- ceed as you would in the case of damage.
2012/06/18 09:56:07 AM
