REMOTE CONTROL
POWER SOURCES
BATTERY INSTALLATION
Slide the battery compartment cover.
Install two “AAA” batteries (not supplied), paying attention to the polarity diagram in the battery compart- ment.
Replace the compartment cover.
BATTERY PRECAUTIONS
The precautions below should be followed when using batteries in this device:
1Use only the size and type of batteries specified.
2Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.
3Do not mix different types of batteries together (e.g. Al- kaline and
4If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (Follow battery manufacturer’s directions).
EFFECTIVE DISTANCE OF THE REMOTE CONTROL
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet.
NOTES: • Never connect the AC line cord plug to anything other than the specified voltage (120V 60Hz). Use the attached power cord only.
•If the polarized AC cord does not fit into a nonpolarized AC outlet, do not attempt to file or cut the blade. It is the user's responsibility to have an electrician replace the obsolete outlet.
•If you cause a static discharge when touching the unit, and the unit fails to function, simply unplug the unit from the wall outlet, wait 10 minutes and plug it back in. The unit should return to normal operation.
AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other.)
TO USE DC POWER
By using the DC car cord supplied with the TV/VCR, you can operate this TV/VCR from a cigarette lighter socket in any car that utilizes a negative ground system.
The fused 12V DC car cord has been designed to power the set from the external DC power (12 volt negative ground) through the TV/VCR DC input jack.
Connect the smaller plug on the end of the cord to the DC input jack on the rear of the TV/VCR, then insert the other end of the car cord into the cigarette lighter socket of your car. Make sure that the cord makes a firm connection.
It may be necessary to try several insertions, rotating the plug for proper electrical connection.
15 FEET
30˚ 30˚
NOTES: • When there is an obstacle between the TV/VCR and the remote control, the remote control may not operate.
• When direct sunlight, an incandescent lamp,
| fluorescent lamp or any other strong light | |
| shines on the Remote sensor of the TV/VCR, | |
10 | the remote operation may be unstable. | |
|
| |
5A3B201A E | 10 | |
TV/VCR | CAR |
|
To Cigarette
Lighter Socket 
To DC Input Jack
| VIDEO |
UHF/ | AUDIO |
VHF | |
OUT | LINE1 |
Car Cord (supplied)
11/4/02, 12:41 PM
