Memorex Tek Partner Universal Remote Control Operating the TEK Partnertm Normal Operation

NOTES:

TV, VCR, and CBL Device Codes can be searched and locked into "CBL" & "AUX" modes. Simply press "CBL" or "AUX" Device Mode Button in step 2 and enter an appropriate Magic Search Code to start searching.

Each time you press the "VOL+" button, the TEK PARTNERTM will skip to the next code. Then press the "PWR" button to send out a POWER signal trying to turn off your device.

If you failed to stop pressing "VOL+" in time when your device has been turned off, turn on your device again immediately. Before the indicator goes out, press "VOL-" on the TEK PARTNERTM to skip backward. Repeat step 4 above and lock in the code.

If the power on/off function of your device is not infra-red controlled, you need to follow steps 1 thru 3 above and start searching: Press "VOL+" and another important function button alternately until your device responds to the expected function, press the same device mode button again to lock in the code. e.g. Press "VOL+" & "1 " alternately, or; Press "VOL+" & "PLAY" alternately until the device responds.

OPERATING THE TEK PARTNERTM

NORMAL OPERATION

Once you have set up the TEK PARTNERTM for your equipment, it works like your original remote controls. To operate, just aim it at your equipment, press an appropriate Device Mode Button and then command the desired function by pressing a corresponding button on the TEK PARTNERTM. The indicator flashes during signal transmission and as confirmation of button touch. At your button touch, your TEK PARTNERTM illuminates the keypad for 4 seconds. You may see the keypad clearly even when you are operating your equipment in a dimly lit area.

PUNCH THROUGH

Punch through allows you to operate your TV’s volume and mute functions and your VCR’s 6 tape management functions without having to switch the device modes repeatedly even when your TEK PARTNERTM is in other operating modes.

MAINTENANCE

1.Do not expose your TEK PARTNERTM to direct sunlight, high temperature, mechanical shock, or liquids.

2.Do not use old and new batteries together as old batteries tend to leak.

3.Do not use corrosive or abrasive cleansers on your TEK PARTNERTM.

4.Keep the unit dust free by wiping it with a soft, dry cloth.

5.Do not disassemble your TEK PARTNERTM, it contains no user-serviceable parts.

TROUBLE SHOOTING

Q. My TEK PARTNERTM does not work at all!

A. If your device’s main switch is turned off, the TEK PARTNERTM can not operate the device.

A. Check whether batteries are in good condition, inserted properly, and are in correct +/- polarity. See

HOW TO INSTALL THE BATTERIES.