Manuals / Brands / Home Audio / CD Player / Meridian Audio / Home Audio / CD Player

Meridian Audio 808.2I 28, To connect to other Meridian G Series or 800 Series equipment

1 38

Download 38 pages, 587.57 Kb

28

Installing the CD

player

To connect to other Meridian G Series or 800 Series equipment

G Series, 500 Series, or 800 Series unit

MERIDIAN

COMMS

Meridian Comms lead

MERIDIAN

COMMS

Meridian 808.2 CD Player

In a system of Meridian products, one of the products

acts as the controller for the system, receiving infra-red

commands from the MSR+ and then, if appropriate,

relaying them to the other products via the Comms link.

The following automatic setup procedure should be

used to set up the Comms correctly between several

products:

Connect one of the DIN COMMS sockets on the

back panel of the CD player to one of the COMMS

sockets on another G Series, 500 Series, or 800

Series unit, using the Comms leads provided with the

products.

The sequence in which you connect the units is not

important.

Switch all the units to standby.

Press Clear (remote).

Each unit will display: Auto

One unit will then be designated as the controller.

The display shows: Controller

•

•

•

All the other units will be configured as non-controllers.

The displays show: Not Con.

If for any reason the automatic setup does not work,

make sure you are operating the remote from a position

where all the units can receive the infra-red, and try

again.

If this fails:

Restore the default operation by selecting one of the

standard types; see

Choosing a standard setting

,

page 30.

Do not, under any circumstances, connect any

equipment other than Meridian G Series or 800

Series to any socket marked COMMS on the back

of the product.

•

Contents

Main ii Safety warnings To avoid overheating To avoid interference Radio interference Contents iv Sales and service in the UK Sales and service in the USA Designed and manufactured in the UK Page 2 The 808.2 Signature Reference CD Player Signal Processing Integrated preamplifier System integration 3 Specifications Drive Audio in and out Signal processing Controls Page Page Using the 808.2 Signature Reference CD Player Front panel keys Using the 808.2 Signature Reference CD Player MSR+ keys 8 Switching on and off To switch on from standby To insert a disc To switch to standby Playing a disc Stopping and pausing play Repeat 12 Scanning a disc To scan through a disc 13 Programming a selection To choose a track to programme To make a selection by adding tracks To make a selection by omitting tracks To add or remove a track from a selection Changing the absolute phase 15 Changing the front-panel display To change the contrast or brightness To change the displayed information 1 68:57 44k1 16Bit LPCM CD Page Page 18 Selecting a source To select a source Adjusting the system volume Page Installing the CD player 22 Unpacking Back panel 23 Installing the CD player Audio outputs Audio inputs (808.2i only) Communications connections Applications To connect to an analogue preamplifier (Type 1 or 2) To connect to an 861 Reference Digital Surround Controller (Type 1 or 2) 25 To connect to two-channel DSP loudspeakers using SpeakerLink (Type 1 or 2)Type 1 or 2) Meridian DSP Loudspeaker User Guide 26 Meridian DSP Loudspeaker User Guide 27 To connect the 808.2/808.2i to a power amplifier (Type 0 or 3)Type 0 or 3) 28 To connect to other Meridian G Series or 800 Series equipment Configuring the CD player 30 Choosing a standard setting To select a standard setting 31 Setting up sources To turn on Gain mode To turn off Gain mode To adjust the sensitivity of a source Page Index A B C D