Mesa/Boogie DC5 manual REAR PANEL continued FX LOOP SEND / RETURN, Fx Mix, Silent Recording

REAR PANEL: (continued)

FX LOOP: SEND / RETURN:

These two 1/4" jacks are the patch point for external effects. The Effects Loop is wired in parallel with the normal signal. Connect the

SEND jack to your Effects Input jack. Connect the RETURN jack to the Output jack of your effect. The Effects Loop is a patch point
				between the pre-amp and power section. Therefore, the Return jack can double as a “Power
		RHY
	IN			Amp Input” jack. When the Return is used as an input, only the 5 Band EQ, the PRESENCE
1.25A		LEAD
	OUT	FT SW
				control of the active channel and the OUTPUT LEVEL control are being utilized, all other con-
FUSE
2.5A SB	EQ SELECT		SEND	trols are inactive.
	FTSW EQ/REV		RETURN

FX MIX:

This control determines the dry/wet blend of the FX Loop signal in relation to the unaffected signal. Set to 0% you will experience only the dry signal (no effect) and at a setting of 100% the entire signal will be wet (total effect.)

	IN	RHY
1.25A		LEAD
	OUT
		FT SW
FUSE			0%	10 0 %
2.5A SB	EQ SELECT		SEND	FX MIX
	FTSW EQ/REV		RETURN

For the best results...Set the mix of your effect to 100% wet. Then dial in the amount of effect that you wish to hear, starting at 0% with the FX LOOP MIX Control. The drier (closer to 0%) signal you use, the better your tone should be. This is one of the advantages in having a parallel type FX Loop designed into your DC-5amplifier...this circuit allows the amplifier to retain its purity with the least possible degredation due to effects impedance mismatching.

RECORDING:

This jack provides direct-to-console interfacing for recording or sound reinforcement applications. It is a circuit dedicated to reproduc-

ing the roll off that occurs in the output section with a speaker connected. With accuracy, it faithfully captures the DC-5’ssoulful
						character. The send level strength is determined by the GAIN and MASTER
		RHY
1.25A	IN					Controls. From this recording jack, adequate signal level will be available to you
		LEAD
FUSE	OUT	FT SW			10 0 %	for most of your recording needs and in live performances as well.
				0%
2.5A SB	EQ SELECT		SEND		FX MIX
	FTSW EQ/REV		RETURN	RECORDING

SILENT RECORDING:

This rocker switch which is located down under the chassis and selects between the live “SPKR ON” setting and the silent “Speaker MUTE” setting. This is a perfect solution for all-nighters! This switch mutes all of the signal at the power section driver stage, removing

the need for a speaker load IN THIS POSITION ONLY!

0%	10 0 %
SEND	FX MIX

RETURN RECORDING

MUTESPKR ON

SILENT RECORDING

NOTE: When this switch is set to the “ON” position, a speaker load must be maintained by either a load resistor of some type or a speaker itself. Failure to comply with this instruction could result in major damage to the amplifier. Leave your speaker connected.

PAGE 8