Important Information on Initial Commissioning
Since an
1.Remove the water filler screw
2.Fill with clean water until the pump is full
3.Screw in the water filler screw
4.Open the pressure line (water tap)
5.Switch on the pump and allow it to run for approx. 1 min
6.Switch off the pump and disconnect the mains plug
7.Open the water filler and drain screw and allow the remaining water to drain out via the water drain screw
8.Screw in the water drain screw
9.Fill with clean water until the pump is full
10.Screw in the water filler screw
11.Slightly open the pressure line (water tap)
12.Connect the mains plug and switch on the pump
13.Repeat the steps again, if required
Failure to observe these technical instructions may lead to foaming in the machine. This prevents the intake of water to the pump. If no water is supplied, the pump is not switched off and the resulting high temperature of the water in the pump head may damage the pump. Caution: Danger of hot water escaping from the pump!
The
The manufacturer cannot be held liable for damage resulting from failure to observe the operating instructions or this supplementary sheet!