Metra Electronics 99-1005 installation instructions ISO Mount Radio with Pocket Provision

99-1005 KIT ASSEMBLY

ISO MOUNT RADIO WITH POCKET PROVISION

*Note: Refer also to the instructions included with the aftermarket radio.

A

1Mount the pocket to the back of the radio housing using (2) of the screws supplied with the kit. (Figure A)

2Mount the rear support bracket to the back of the pocket using the remaining (2) screws supplied with the kit. (Figure A)

3Mount the ISO Brackets to the after- market radio using the screws sup- plied with the radio. (Figure B)

4Slide the radio into the radio open- ing until the side clips snap into place. (Figure C)

5Snap the trim plate onto the front of the Radio Housing. (Figure D)

Continue to final assembly.

Note:

To remove the radio from the radio housing, unclip and remove ISO trim-plate. Then use a small flat blade screw driver to release the ISO snap in brackets and slide the radio out of the radio housing.

D

B

C

4