99-1005 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B)Twist ends together
C)Solder
D)Tape
1Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.)
2
3(All Sedona and Spectra ISO mount radio only) Reassemble radio and dash assemblies in reverse order of disassembly.
(Spectra DIN radio only) Place assembled kit into the radio cavity in the dash, do not bolt in.
4(Spectra DIN radio only) Snap the dash panel back into place over the dash. Pressure fit the kit between the dash and the dash panel.
5(Spectra DIN radio only) Slide the DIN cage into the radio opening in the dash panel and radio housing. Secure the cage by bending the metal locking tabs outward.
6(Spectra DIN radio only) Slide the aftermarket radio into the cage until it snaps into place.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V | Ignition / Acc | Red | Right Front (+) | Gray |
12V | Batt / Memory | Yellow | Right Front | Gray/ Black |
Ground | Black* | Left Front (+) | White | |
Power Antenna | Blue | Left Front | White / Black | |
Amp | Blue / White | Right Rear (+) | Violet | |
Amp Ground | Black / White | Right Rear | Violet / Black | |
Illumination | Orange | Left Rear (+) | Green | |
Dimmer | Orange / White | Left Rear | Green / Black | |
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
5
