Metra Electronics 99-7013 installation instructions Final Assembly

99-7013 FINAL ASSEMBLY

FINAL ASSEMBLY

A

(A) Strip wire ends back 1/2"

B	B) Twist ends together
	C) Solder
C	D) Tape
D

1Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)

2Re-connect the negative battery terminal and test the unit for proper operation.

3Reassemble radio and dash assemblies in reverse order of disassembly.

FINAL WIRING CONNECTIONS

Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit.

METRA / EIA WIRING CODE
12V	Ignition / Acc	Red	Right Front (+)	Gray
12V	Batt / Memory	Yellow	Right Front (-)	Gray/ Black
Ground		Black*	Left Front (+)	White
Power Antenna		Blue	Left Front (-)	White / Black
Amp Turn-On		Blue / White	Right Rear (+)	Violet
Amp Ground		Black / White	Right Rear (-)	Violet / Black
Illumination		Orange	Left Rear (+)	Green
Dimmer		Orange / White	Left Rear (-)	Green / Black

*NOTE: When a Black wire is not present, ground radio to vehicle chassis.

All colors may not be present on all leads due to manufacturer’s specifications.

7