Metra Electronics 99-3410, AW -341GO Suzuki Aerio, GEO Metro / Suzuki Swift Suzuki Esteem

CHEVROLET Tracker 1998-04 • GEO Tracker 1992-97 SUZUKI Sidekick 1992-98 / Vitara series 1999-04

SUZUKI Aerio 2003

1

2

1

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the cigarette lighter and climate control knobs. Remove the ashtray and (1) screw exposed. Pull out on the climate control cluster and remove (2) screws exposed. Unclip the radio trim bezel. Remove (4) screws from the factory head unit, slide the unit out and disconnect the wiring.

2

Fig. B

BFig. A

B

B

Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "B". (The mounting tabs can be identified by the stamped letter on the back of each tab). (see Fig. A). Cut and remove the (2) side clips on the back side of the radio trim bezel. (This will provide proper clearance when re-attaching the bezel after the aftermarket head unit has been installed).

(see Fig. B). Skip to the Installation Instructions for ALL VEHICLES on Page #3.

Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the dash trim bezel and remove. Remove

(4)Phillips screws securing the factory head unit and disconnect the wiring.

B

B

B

B

Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "B". The mounting tabs cab be identified by the stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL VEHICLES on Page #3.

GEO Metro / SUZUKI Swift 1992-94

SUZUKI Esteem 1995-03

1 2 A

A

1

2

B

B

B

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the climate control knobs. Remove (1) Phillips screw above and (2) Phillips screws below the climate controls. Unclip the radio trim bezel. Remove (4) screws from the factory head unit, slide the unit out and disconnect the wiring.

1

A

Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "A". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL VEHICLES on Page #3.

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the climate control knobs. Remove (1) Phillips screw located above the radio opening. Unclip the radio trim bezel. Remove (4) screws from the factory head unit, slide the unit out and disconnect the wiring.

B

Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "B". The mounting tabs cab be identified by the stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL VEHICLES on Page #3.

2