Metra Electronics LC-GMRC-LAN-01 Applications, Wire Connections to be Made

Models: LC-GMRC-LAN-01

1 2
Download 2 pages 3.75 Kb
Page 2
Image 2

TOOLS REQUIRED FOR INSTALLATION

Cutting Tool • Tape • Crimping Tool

Connectors (ie: butt-connectors, bell caps, etc.)

APPLICATIONS

APPLICATIONS

BUICK

Enclave

2007 - 09

BUICK

Lucerne

2006

- 09

CADILLAC

DTS

2006

- 09

CADILLAC

SRX

2007

- 09

CHEVROLET

Avalanche

2007 - 09

CHEVROLET

Equinox

2007 - 09

CHEVROLET

Express van (full size)

2008 - 10

CHEVROLET

Impala

2006

- 07

LC-GMRC-LAN-01

WIRE CONNECTIONS TO BE MADE

*Important: Before beginning any of the following, disconnect the negative battery terminal to prevent accidental short circuit.

1.Connect the Yellow wire to the radios constant/memory wire.

2.Connect the Red wire to the radios accessory wire.

3.Connect the Black wire to the radios ground wire.

4.Connect the Blue wire to the radios antenna turn on.

5.Connect the White wire to the radios left front (+) speaker wire.

6.Connect the White/Black wire to the radios left front (-) speaker wire.

7.Connect the Gray wire to the radios right front (+) speaker wire.

8.Connect the Gray/Black wire to the radios right front (-) speaker wire.

9.Connect the Green wire to the radios left rear (+) speaker wire.

10.Connect the Green/Black wire to the radios left rear (-) speaker wire.

11.Connect the Purple wire to the radios right rear (+) speaker wire.

12.Connect the Purple/Black wire to the radios right rear (-) speaker wire.

INSTALLING THE LC-GMRC-LAN-01

1.With all connections completed reconnect the negative battery terminal.

2.Plug the LC-GMRC-LAN-01 into the vehicle and into the radio.

3.Cycle the key by turning the ignition on then back off, then on again.

TESTING THE LC-GMRC-LAN-01

1.Turn the radio on and test for proper balance and fader operation.

2.Close the doors then turn the key off. The radio should stay on until the driver’s door is open.

NOTE: If the radio you are installing requires more then 3 amps on the acces- sory wire, or you are adding another accessory to the wire (hardwire radar detector, etc…) then a relay will be needed to supply the additional current.

See the diagram below to properly add a relay:

CHEVROLET

Monte Carlo

2006

- 07

CHEVROLET

Silverado Pickup (New Body)

2007 - 09

CHEVROLET

Suburban

2007 - 09

CHEVROLET

Tahoe

2007 - 09

CHEVROLET

Traverse

2009 - 10

GMC

Acadia

2007

- 09

GMC

Savanna Full Size Van

2008 - 09

12v Accessory from LC-GMRC-LAN-01 Red

+12v Battery Fused

SPDT Relay

87

8586

87a

GMC

Sierra (New Body)

2007 - 09

GMC

Yukon XL / Denali

2007 - 09

GMC

Yukon

2007 - 09

PONTIAC

Torrent

2007 - 09

SATURN

Outlook

2007 - 09

SATURN

VUE

2008 - 09

SUZUKI

XL-7

2007 - 09

30

To Radio

2

3

4

Page 2
Image 2
Metra Electronics Applications, Wire Connections to be Made, Installing the LC-GMRC-LAN-01, Testing the LC-GMRC-LAN-01