3 Connect to the Network
The Lancast CenturySwitch is compatible with both 10Base-T and 100Base-TX devices. Network connections are made by simply plugging the cables into the RJ-45 port connectors on the front panel as shown in the figure below. Each port supports a maximum segment length of 100 meters over Category 5 UTP cables for 100Base-TX segments and Category 3, 4 or 5 UTP cables for 10-Base-T segments. Once power is applied to the unit, use the individual Link/Act LEDs to verify correct segment connectivity.
| ® | | | | | | | | | | 10/100 Ethernet Switch | | |
| CenturySwitch ® | | | | | | | | | | | | | | Module Port 8 |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 1x | 2x | 3x | 4x | 5x | 6x |
| 7x |
| Link/Act | | | | | | | | | | | | | | |
| 100Mbps | | | | | | | | | | | | | | |
| Power | | | | | | | | | | | | | | |
| 3508-11 | | | FDX | | | | | | | | | | -II |
| | | | | | | | | | | | | | |
Fixed Ports
The CenturySwitch provides seven fixed RJ-45 ports with connectors for devices wired crossover. The ports are labeled 1x through 7x. These dual- speed ports are 10/100Mbps auto-sensing and will automatically detect and operate at the speed of the connected device.
Module Port
Port 8 provides two RJ-45 connectors which support a device wired either crossover (MDI-X) or parallel (MDI-II).
IMPORTANT: Do not connect devices to both the MDI-X and MDI-II connectors at the same time. This can damage the unit and void its warranty.
6 Installation Guide
