Metrologic Instruments IS1650

DEFAULT SETTINGS

Many functions of the scanner can be “configured” – that is, enabled or disabled.

The scanner is shipped from the factory configured to a set of default conditions.

The default parameter of the scanner has an asterisk (*) in the charts on the

following pages. If an asterisk is not in the default column then the default setting

is OFF or DISABLED. Not every interface supports every parameter. If the

interface supports a parameter listed in the charts on the following pages, a

check mark () will appear.

PARAMETER DEFAULT RS232 IBM 46XX

RS485

KBW

KEYBOARD

USB

Multi-Try Trigger, Out-of-Stand    

Presentation Mode, In-Stand *    

Presentation Mode, Out-of-Stand *    

Continuous Trigger    

Single Trigger    

Aiming in

Trigger and Continuous Modes *    

Aiming in Presentation Mode *    

Long-Range In-Stand *    

Short-Range In-Stand    

Long-Range Out-of-Stand *    

Short-Range Out-of-Stand    

UPC/EAN *    

Code 128 *    

Code 93 *    

Codabar *    

Interleaved 2 of 5 (ITF) *    

MOD 10 check on ITF    

Code 11    

Code 39 *    

Full ASCII Code 39    

PDF *    

Data Matrix    

QR Code    