10
INSTALLING THE SCANNER TO THE HOST SYSTEM
1. Turn off the host device.
2. Plug the male 10-pin RJ45 end of the
MVC cable into the 10-pin socket on
the scanner. There will be an audible
click when the connector lock
engages.
3. Connect the other end of the MVC
cable to the host device.
4. Turn on the host device.
5. The scanner will start to initialize.
All LEDs (yellow, white, and blue) will
light for approximately two seconds
then start to alternately flash. When
the scanner has finished initializing
the LEDs will stop flashing and the
unit will beep three times indicating
that the scanner is ready for use.
S Applicable for IBM® Host applications.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. The scanner is shipped from the factory configured with default
settings. Please refer to the MetroSelect Single-Line Configuration
Guide (MLPN 00-02544) or MetroSet2’s help files for instructions on
changing the scanner’s configuration. In addition, please check that the
scanner and host system are using the same communication protocol.
See power source caution statement located on page 6 of this manual.
Figure 9.