20
SCANNER CONFIGURATION BAR CODES
The following bar codes can be used to place, as well as configure, the
scanner in Dual Cable mode.
The MS2xx0 does not need to be in scale program mode to use the
following bar codes.
Scanner = Dual Cable Mode
³999953
Places the scanner in Dual Cable mode.
In a dual cable environment, the scanner
and scale work independently. In this mode
the host must have a dedicated RS232 port
to receive the scale data and the bar code
data is sent via its own cable to a separate
communication port.
Communication Port Settings:
• 9600 Baud, 8 Data Bits, 1 Stop Bit, No Parity
There are two methods of configuring the scanner to a stand-alone protocol:
• Scan the Dual Cable Mode bar code on this page (if a scale is used)
or
• If no scale is required, scan one of the single cable protocols on
pages 23 - 32 and then scan the No Scale bar code on page 44.
Scanner Only
Dual Cable OPOS Defaults
³999911
Use this bar code when the scanner is to be
setup using the OPOS drivers in the dual
cable mode.
Communication Port Settings:
• 9600 Baud
• 8 Data Bits
• 1 Stop Bit
• No Parity