Metrologic Instruments MS5100 no

1. Connect the 10-pin RJ45 plug of the PowerLink cable into the jack on the

MS5145 USB scanner.

Note: The MS5145 USB scanner will receive power directly from the host

system; no external power supply is required.

2. Connect the USB connector of the PowerLink cable into the USB port of the

host system.

3. When the MS5145 is ready to scan, the green LED will turn on, the red LED

will flash and the scanner will beep once.

Contents

Main Page ii L T ABLE OF C I Eclipse A CCESSORIES AND S Q UICK S p no s q STANDARD RS232 SCANNER INSTALLATION s q p n or KEYBOARD WEDGE SCANNER INSTALLATION KEYBOARD WEDGE INSTALLATION (CONTINUED) USB SCANNER INSTALLATION no Page S CANNER P AUDIBLE INDICATORS VISUAL INDICATORS FAILURE MODES Page L T ROUBLESHOOTING G Page Page Page RS-232 D M APPENDIX A O M APPENDIX A (CONTINUED) E 22 APPENDIX B Default Settings Page Page Page Page Page Cable Connector Configurations Page 31 APPENDIX D Warranty and Disclaimer Limited Warranty APPENDIX E Notice Caution Remarque Attention APPENDIX F