Configuration to the Host System
The scanner is shipped from the factory programmed to a set of
default conditions noted in the ScanSelectâ„¢ Scanner Programming
Guide by an asterisk that appears before the brief definition located
next to the bar code.
In order for the scanner to communicate with a host system properly, it
may need to be programmed. Since each host system is unique, con-
figure the scanner to match the host system requirements. Configure
the scanner by entering the program mode and scanning the appro-
priate bar codes that appear in the ScanSelect Scanner Programming
Guide. (To use ScanSet®, refer to the ScanSet documentation for
information on how to configure a scanner.)
1. Connect the scanner to the host system (Refer to the Scanner
Connections to the Host section in this guide).
2. Enter program mode by scanning the ENTER/EXIT program
mode bar code. The unit will beep three times
3. Scan the appropriate bar code(s) that appear in the
ScanSelect Scanner Programming Guide. Reveal only one
bar code to the scanner each time. With your hand, cover the
bar code not to be scanned.
4. Exit program mode by scanning the ENTER/EXIT program
mode bar code again. The new options will be saved and the
scanner is ready for normal operation.
3