![](/images/new-backgrounds/1116497/11649741x1.webp)
MONTHLY LUBRICATION
L12
Maintain oil level in the corner gearbox at the centerline of the input shafts. Check regularly for any observable oil leakage. If oil leakage is excessive, replace required input/output shaft oil seals. Use ONLY EP
ON CORNER OF FRAME
L13
Grease (1) brass bushing supporting the rear shaft of the 3rd auger assembly. This zerk is located on the left rear corner of the tank above the inner cross brace.
L14
Maintain the lube level in the (2) spinner gear- boxes at 3/4 full. Check regularly for any observable leakage. If leakage is excessive, replace required in- put/output shaft seals. Lubricate with
L1
5
Clean and repack the wheel hubs with axle grease annually. Grease hub through zerk in hub monthly. Be careful not to over grease and force seal out of back side of hub.
L16
Oil slides on front idler tightener assembly.
ON CORNER OF FRAME
L17
Grease (4) material guide pin sleeves. (2) lo- cated on each side of the spreader.
L18
Grease (2)
(SHIELDS REMOVED FOR ILLUSTRATIVE PURPOSES ONLY.)
Model 8720/8865 |