691 System Installation Checklist
NOTE: As you install the 691 System complete this check list. Upon completion of the 691 installation, retain this checklist with the 691 Operation and Installation Manual.
Date installed: _______________ Name of person(s) installing: ______________________________________
Vehicle make:______________________________Model: _______________________Year: _______________
Vehicle I.D. number: _________________________________________________________________________
Model number of 691 System installed: _________________________________________________________
Complete this section after Mounting the 691 System
Yes | No | 1. | Is the 691 Power Unit mounted upright and level? |
|
|
|
|
Yes | No | 2. | Is the power unit breather plug clean and away from contaminants? |
|
|
|
|
Yes | No | 3. | Can the fluid in the power unit reservoir be easily checked? |
|
|
|
|
Yes | No | 4. | Is the actuator(s) mounted at a lower level than the vehicle master cylinder? |
|
|
|
|
Yes | No | 5. | Is the actuator mounted horizontally level with bleeder screws facing up? |
|
|
|
|
Yes | No | 6. | Is the user interface (if used) mounted where it can be easily seen and away from where it will get |
N/A |
|
| spilled on? |
|
|
|
|
If you have checked "no" in any of the above boxes, determine the reason and correct.
Complete this section after Plumbing the 691 System
Yes | No | 1. Are all fluid lines properly connected as shown? | ||
|
|
| From |
|
|
|
| Master Cylinder |
|
|
|
| (port not shown) |
|
|
|
| To Brakes |
|
|
|
|
| To |
|
|
|
| Brakes |
|
|
|
| From |
|
| From | From | Power Unit |
|
| Power Unit | Master Cylinder | To |
|
|
|
| Brakes |
From
Master Cylinder (port not shown)
Yes | No | 2. Is the unused port on the power unit pump manifold properly plugged? |
Plug One of
These Ports
Yes | No |
| 3. | Have all upward "U" shapes in the fluid lines where air can be trapped been |
|
|
|
| eliminated? |
|
|
|
|
|
Yes | No |
| 4. | Have fluid line connections between flexing vehicle sections been made using coiled |
|
|
|
| tube or brake hose that will absorb shock? |
|
|
|
|
|
Yes | No |
| 5. | Is there a proper fluid level of clean appropriate fluid in the power unit reservoir or |
|
|
|
| remote reservoir? |
|
|
|
|
|
Yes | No | N/A | 6. | If an optional remote reservoir is used, was the power unit reservoir topped off first? |
|
|
|
|
|
Yes | No |
| 7. | Is the vehicle master cylinder reservoir at the full level with proper fluid? |
If you have checked "no" in any of the above boxes, determine the reason and correct.