Utility
The Utility function is available for erasing inserted cards and updating the Duplicator firmware.
Measure Speed
The Measure Speed function can be turned on to measure the exact speed of the flash read and write.
Media Check
This function checks the media quality, and can be set to 3 different levels: Normal 100%, Strict 100%, and Setup Range. Regardless of the setting, if the check detects a read or write error, the LED for that flash card will show red.
Normal 100% will use bit 0 to perform a write and read to examine the flash quality. Strict 100% will use bits 0 and 1 to perform a write and read to examine the flash quality. Setup Range allows you to specify the percentage of the flash media that gets checked. The range can be set from 1% to 100%.
Quick Erase
This will perform a quick erase on any card inserted into any port, including the reader port. Do not run the erase function with your master card in the duplicator.
Full Erase
This will perform a full erase on any card inserted into any port, including the reader port. Do not run the erase function with your master card in the duplicator.
System Update
This will update the system firmware from the card in the Reader port. Do not attempt to perform an update unless directed to by Technical Support.
Setup Menu Flowchart
6. Setup
OK
1.
▼
2.Copy Area
▼
3.Button Beep
▼
4.Asyn Hold Time
▼
5.Ignore Size
▼
6.Asynchronous
▼
7.Language
OK
OK
OK
OK
OK
OK
OK
This setting specifies which of the 6 Main Menu items is the default that shows on
This setting can be set to
Only Data Area and Whole
Area.
Turn the Button Beep ON or OFF.
This setting determines how long the system will wait before continuing or exiting an Asynchronous duplication job.
Sets the tolerance percentage of source and target flash capacity difference.
This must be set to ON for
Asynchronous duplication.
This setting specifies the language displayed on the interface.
10
