Before Setting Oven Controls
Oven Vent Location
The oven is vented through the upper control panel trim and grille or through the bottom grille of the upper control panel. When the oven is on, warm air is released through the vents. This venting is necessary for proper burner operation in the oven and good baking results. DO NOT block the vents. Doing so may cause baking failures, fire or damage to the wall oven.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Single Oven Models |
Double Oven Models |
Some models have 2 flat racks. Other models have one flat rack and one offset rack. The rungs on the offset rack are slightly raised from the edges of the rack. This raised part of the rack is designed to allow easy and safe removal of foods from the lower racks of the oven and prevent hands from contacting the hot oven door. Always use the offset rack in the lower position.
Air Circulation in the Oven
If using 1 rack, place in center of oven. If using multiple racks, stagger cookware as shown.
For best air circulation and baking results allow
1 Oven Rack
Multiple Oven Racks
Setting Oven Controls
Refer to the Electronic Oven Control Guide supplied with your appliance for oven settings.
6
