Middleby Marshall PS536-Series Conveyor Reassembly Into Oven, Checking Conveyor Belt Tension

SECTION 4

MAINTENANCE

F. Conveyor Reassembly Into Oven

1. Lift conveyor and position it in oven as shown.

NOTE: Conveyor assembly may be inserted into either end of oven. If it is to be installed from the non-drive end of the oven the drive sprocket assembly must be removed as shown in conveyor disassembly section.

NOTE: Split belt conveyors can only be inserted from the drive end of the oven.

Figure 4-22.

2.Reinstall the conveyor rear stop. Reinstall the con- veyor end stop.

Conveyor Rear Stop

Middleby

Marshall

Conveyor End Stop

G. Checking Conveyor Belt Tension

WARNING

Oven conveyor belt must be cool when adjusting belt. Do not adjust belt if HOT.

1.With the conveyor assembly in the oven, stand at one end of conveyor and check tension by lifting the conveyor

belt at the center of the oven chamber opening. The belt should not lift higher that 3″ to 4″ (75mm to 102mm).

2.Adjust conveyor belt tension screws (located on left end of oven) for the 3″ to 4″ (75mm to 102mm) deflection as shown in Figure 4-26. If there is proper tension, proceed to “J. Attaching Drive Chain”. If belt is still too loose, continue to step 3 below.

3.If conveyor belt is still not under proper tension, an entire link must be removed. Use the following procedure “H. Conveyor Belt Link Removal” to remove a link. If conveyor belt is under proper tension proceed directly to “J. Attaching Drive Chain”.

Figure 4-24.

Figure 4-23.

36