
OWNER’S MANUAL FOR THE
FEATURES AND LOCATION OF CONTOLS
TURNING THE RADIO ON OR OFF:
The ON/OFF VOLUME control at the top of the radio and controls power and volume. When the radio is switched on, series of tones will be heard confirming that radio is working. (If enabled)
CHANGING THE CHANNEL:
Press and release the channel /\ or \/ button to select the desired channel. To change channel rapidly, press and hold the channel button /\ or \/ until the desired channel appears on the display and release the button.
Warning: When using the
ACTIVATING SCAN FUNCTIONS
The
Busy Channel Scan:
1.Press and release the ”F” button one time, the ”SCAN” icon (2) will begin flashing in the upper part of the display.
2.Press and release the /\ or \/ channel button to activate scan. The unit will now begin scanning through the channels.
Pressing the /\ or \/ channel button during scan will determine if the channels are scanned up or down.
Pressing the “PTT” (push to talk) button will cause the radio to stop scanning and return to normal operate mode.
3. To reactivate scan repeat steps above.
Open Channel Scan:
1.Press and release the “F” button repeatedly (usually twice) until the “B.SCAN” icon (2) flashes in the upper part of the display.
2.Press and release the /\ or \/ channel button to activate scan. The radio will begin to scan for OPEN channels.(channels not in use)
Scanning will stop on the first available open channel for about 5 seconds then move to the next open channel.
3.Press the “PTT” button to stop scanning and talk on that channel.
4.To reactivate scan repeat steps above.
Dual Watch - Dual watch is a function that allows you to scan only two channels.
1.Select channel one. This will be the channel that is on the display when you start the scan.
2.Press the “F” button repeatedly (usually 3 times) until “DW” (3) is flashing in the upper part of the display.
3.Select the second channel to be scanned. This must be done without any delay between button presses.
About 1 second after your selection of the second channel is complete the radio will begin switching between the two channels.
When the radio hears activity on either channel, scanning will stop on that channel for about 5 seconds and then resume scanning.
If communication is desired on the channel scanning stopped on, press the “PTT” button. This will deactivate Dual Watch and allow you to communicate normally.
4. To reactivate Dual Watch, repeat steps above.
| http://www.midlandradio.com | Page 6 of 12 |
|
|
|
|
|
|
|
|
|