Miele DA362-110 Recirculation connection, Installation, Recirculation mode, Reducing collar

Installation

Recirculation mode Recirculation connection

If site conditions are not suitable for the hood to be used for air extraction, the appliance must be converted for recirculation.

For recirculation mode the following accessories can be ordered from your Miele dealer or the Technical Service Department:

– 2 conversion kits for recirculation mode

– 4 active charcoal filters

Reducing collar

^The reducing collar must be used in recirculation mode. Place the collars into the exhaust connections and turn left to lock them in place. Do not insert the non-return flaps.

^In recirculation mode, 2 cut outs must be made, where the ducting ends, for the installation of the recirculation vents, b.

If installing the hood over an island or in a cabinet at ceiling height, a suitable cut-out has to be made in the front panel, d.

^The exhaust connection, a, and the recirculation vent, b, are joined together with a pipe or flexible duct, c, cut to size.

When installing the recirculation vents make sure that the slats point towards the center of the room and not to a wall or the ceiling.

^Install the active charcoal filters (see "Cleaning and Care").

30