Electrical connection
All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer can not be held responsible for unauthorized work.
Ensure that power to the appliance is OFF while installation or repair work is performed.
Verify that the voltage, load and circuit rating information found on the data plate (located behind the grease filter), match the household electrical supply before installing the hood.
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele’s Technical Service Department. See back cover for contact information.
WARNING:
THIS APPLIANCE MUST BE GROUNDED
Important
To increase security before the machine is installed, it is recommended to install a protective switch (30 mA).
CAUTION
Connect only to a
Remove the vapour canopy and the grease filters from the range hood (see “Cleaning and Care”).
The electrical junction box is located on the inside rear right of the range hood.
Loosen the screws and remove the cover.
Feed the power line from your house installation through the cable opening in the casing.
Connect the cables to the terminal clamps.
Important
The hood must be hard wired accordingly:
Black/Red wire:. . . . connect to L1 (live)
White wire: . . . . . connect to N (neutral)
Green wire: . . connect to GND (ground)
Close up the junction box again and
24
