Black & Decker PRJE600 manual How to use your Juicer, Inlet Adaptor

English

Fig A - Before first use:

Before using your Juicer for the first time, make sure it is disconnected from the electrical supply, then remove all packaging from the sieve & pulp container.

To remove the packaging, open the right- hand latch (7), then the left-hand latch (8).

Lift the cover (5) from the appliance.

Remove the packing from the sieve (12) and the pusher from the pulp container (3).

Pull the sieve housing & sieve from the Juicer.

All parts must be cleaned as recommended in the section “How to take care of your Juicer”.

The motor housing must only be cleaned with a damp cloth, and dried thoroughly before use.

Inspect the sieve for signs of damage.

Note: Do not use the appliance if the rotating sieve is damaged.

Fig B - How to assemble your Centrifugal Juicer

Place the sieve housing (13) on the motor housing (1), then place the sieve (12) into the sieve housing, pressing it onto the sieve adaptor (14).

9

9

must then be gently pushed down and rotated in an anti-clockwise direction until it locks in place.

A separate pusher (9) is provided for use with the adaptor.

Warning: Never use the pusher (9) without the adaptor in place as damage may occur.

To process round ingredients remove the adaptor by rotating it in a clock-wise direction then lift it from the inlet (8).

The pusher is used by first aligning the groove with the rib in the inlet the pushing it down gently.

How to use your Juicer

This appliance is designed to extract juice from fruits & vegetables.

Do not use this appliance for any other purpose. For indoor domestic use only.

Prepare material to be processed by washing thoroughly and peeling as required. Remove all pips and large seeds. Large items may need to be cut into pieces to fit the inlet chute

(8).

Smaller items may be placed directly into the chute (8) and guided into the Juicer using the relevant pusher (9).

Make sure the speed switch (2) is in the ‘’0’’ (OFF) position, then plug the cord-set into a power outlet.

8

10

9

Place the cover (5) on top of the seive housing. Fit the hooks of the latches over the recesses in the cover, then push the right- hand latch (7) and the left-hand latch (8) down ensuring they lock in place.

Fit the pulp container (5) onto the Juicer, making sure the rib on the container locates into the slot in the appliance.

Inlet Adaptor

The inlet can be adapted to suit various ingredients. Large round items such as apples can be processed with no adaptor however long ingredients such as carrots work better with the adaptor (11) in place.

The adaptor (11) is fitted by first aligning the groove with the rib in the inlet. The adaptor

Note: Make sure that the voltage shown on the underside of the motor housing corresponds with the local supply voltage.

Press the switch to select speed l or ll as required.

Press the switch to select speed l or ll as required. Low speed should be used for soft fruits and high speed for harder fruits.

Check the pulp collector is in place, and place a suitable container under the spout (6). Place the ingredients into the inlet chute. The pusher (11) can be used to gently guide the ingredients down the inlet chute. Do not overload the machine. Too much pressure may cause material to jam the inlet chute.

Note: Juice may continue to flow after the appliance has been turned off.

-4-