
Before using for the first time
Programming the water softener
To exit the programming mode at any time turn the dishwasher off with the button.
Press the button to turn the dishwasher off.
Press and hold the "Start / Stop" button and turn the dishwasher on simultaneously using the button. Keep the "Start / Stop" button pressed for at least four seconds until the "Start / Stop" indicator light comes on.
If it does not come on, start over.
Now press the "Delay Start" button twice.
The characters "P 1 5" will flash one after the other in the display. This means that the water hardness level has been set at 15 °d [16 gr/gal (factory setting)].
The value which has been set for the water hardness is shown as a figure after the "P" in the display (see chart).
Use the "Start / Stop" button to select the flashing rhythm that corresponds to your water hardness level.
With each press of the button the value will raise one level. Once the highest value is reached the setting will start again from the beginning.
Press the button to turn the dishwasher off.
|
| Value |
°d | gr/gal | displayed |
|
|
|
1 | 1 | 1 |
2 | 2 | 2 |
3 | 3 | 3 |
4 | 4 | 4 |
5 | 5 | 5 |
6 | 6 | 6 |
7 | 7 | 7 |
8 | 8 | 8 |
9 | 9 | 9 |
10 | 10 | 10 |
11 | 11 | 11 |
12 | 13 | 12 |
13 | 14 | 13 |
14 | 15 | 14 |
15 | 16 | 15 |
16 | 17 | 16 |
17 | 18 | 17 |
18 | 19 | 18 |
19 | 20 | 19 |
20 | 21 | 20 |
21 | 22 | 21 |
22 | 23 | 22 |
23 | 24 | 23 |
24 | 25 | 24 |
25 | 26 | 25 |
26 | 27 | 26 |
27 | 28 | 27 |
28 | 29 | 28 |
29 | 30 | 29 |
30 | 31 | 30 |
31 | 32 | 31 |
32 | 33 | 32 |
33 | 34 | 33 |
34 | 35 | 34 |
35 | 36 | 35 |
36 | 38 | 36 |
50 | ||
60 | ||
70 | ||
|
|
|
12