Use
Time display
Before the program starts, the time display shows the runtime of the selected program in hours and minutes. The remaining time is displayed during the program.
The time that is displayed may vary for the same program. It depends on the temperature of the incoming water, the reactivation cycle, the type of detergent and the quantity and soiling of the dishes.
When a program is selected for the first time, the display shows an average program time for cold water.
With every program, the electronics correct the time according to the temperature of the incoming water and the size of the load.
Standby
A few minutes after the last button is pressed or a few minutes after the end of the program the dishwasher will switch to Standby mode to save energy. The time display and the indicator lights are turned off and only the indicator light flashes slowly.
Press the button if you want to turn the indicator lights back on.
If the dishwasher is not turned off after the program ends, after a few minutes in standby mode it will turn off completely (see "Additional options - Optimize Standby").
If Salt and/or Rinse aid or a fault is displayed, the dishwasher will not switch to Standby mode.
If you use a Tab detergent, you can deactivate the refill messages and let the dishwasher go into Standby mode (see "Before using for the first time").
However, fault messages cannot be turned off.
34
