Connection to the water supply

,Installation, repairs and other work
by unqualified persons could be
dangerous.
,Do not drink water from the
dishwasher!
–The dishwasher can heat its own water
to the temperature required by the
wash program. This allows for
connection of the machine to either a
hot (max. 140°F / 60°C) or cold water
source.
For lowest energy consumption and for
fastest possible wash times connect
the dishwasher to a hot water source.
All programs use hot water in the rinse
cycles.
– To use the "Energy Saver" program, a
hot water connection of minimum
115°F / 45°C and maximum 140°F /
60°C (water intake temperature) is
necessary.
The higher the water intake
temperature, the better the cleaning
and drying results.
–The inlet hose is approximately 5 ft.
(1.5 m) long.
–The water inlet hose comes
equipped with an inlet hose ending
with a 3/8" female compression
fitting. This can be directly
connected to a water supply valve or
to an appropriate coupling.
If not connected directly to a water
supply valve, an appropriate
adapter (not included) is required.
–Water pressure: Must be between
4.5 - 145 psi (0.3 - 10 bar).
–If the water pressure if lower, a
"Water Intake" notification will be
shown. See "Frequently Asked
Questions" for more information.
–If the water pressure is higher than
shown, a pressure reducing valve
must be used.
Ensure that the water connection is
secure after the first use.
,To prevent damage to the
dishwasher, it must only be
connected to a fully vented drainage
system.
,Do not cut the intake hose. If the
hose is cut, the dishwasher will not
work. There will be a water leak. If
the hose is too long, coil it neatly
and place it behind or under the
machine.
Plumbing
71