Miele KM 6215 Problem Possible cause Remedy Will flash, Alternating with 9, Cooking zone display

	Problem solving guide
Problem	Possible cause	Remedy
A 0 will flash	The overheating	See "Overheating protection".
alternating with 9 in the	protection mechanism
cooking zone display.	has triggered.
The hob switches off	One or more of the	Clean the control panel or
while it is in use and an	sensors have been	remove the obstruction (see
F flashes in the timer	covered, e.g. by finger	"Safety switch-off").
display.	contact, food boiling
	over or by an object
	such as an oven glove.
The food in the pan	There is too much food	Start cooking at the highest
hardly heats up or does	in the pan.	power level and then turn
not heat up at all when		down to a lower one
the Auto heat-up		manually later on.
function is switched
	The pan is not
on.
	conducting heat
	properly.
One or more residual	There was an	The hob can be used again.
heat indicators are	interruption to the	Check the cooking stage of
flashing.	power supply during	the food and whether its
	operation, and the hob	condition has been affected
	has switched itself off.	by the power failure before
		switching the cooking
		zone(s) back on again.
	The residual heat	The indicators will flash until
	indicators have lit up	the maximum residual heat
	while the programming	time has elapsed or the
	mode was being called	cooking zone is selected and
	up.	activated.
It is taking too long for		You can test the power level
the contents of the pan		of the cooking zone (see "To
to come to the boil.		test the power level").

55