Use
6.Program end - Unload the laundry
The "End" indicator will light at the end of the program and the buzzer will sound if it was selected.
The indicator of the reached drying degree lights (depending on program).
To avoid wrinkles, the drum turns in intervals for up to one hour, if the laundry is not immediately removed.
Open the door.
If the door remains open, the light goes off after a few minutes (saving energy).
Remove the laundry.
Check the drum for any missed pieces of laundry. Any items left in the dryer may be damaged because of over drying.
Clean the lint filter after each use (see "Dryer care").
Take care when inserting the lint filter not to hurt your fingers.
Insert the lint filter with the yellow handle edge towards the drum.
Close the door.
Changing a running program
A running program cannot be changed (protection from accidental changes).
To select a different program the running program must be canceled.
To cancel a program
Press the "Start/Stop" button.
The laundry will be cooled in case a certain drying time and temperature were reached.
If you press the "Start/Stop" button again during the cooling phase, the "End" indicator lights and the drum stops.
Open and close the door.
Select the new program.
Adding/removing laundry during a drying program
Open the door.
Do not touch the rear of the drum while adding or removing items! Danger of burns.
Add or remove items.
Close the door.
Press the "Start/Stop" button.
16
